i found a manual for the matsonic MS8308EP, which has important things like jumper settings and which pins take which connectors – i had it all hooked up and ready to fire up last night, but i couldn’t figure out which pins the power swich was connected to, so i couldn’t actually fire it up until this morning. but it does POST, and now all i have to do is make the correct settings in the CMOS and then i can start putting the office back together again.
One thought on “almost to the end of argh, this time”
Comments are closed.
Whoo. thank goodness thigns have finally settled down for you. Now you can go on your merry way to upgrading, when you get the time. That should be pretty fun. Yours will hopefully run smoother than mine did.